THIS ALUMINUM MIG WIRES A BARGAIN

If you get your aluminum MIG wire at a bargain price, its likely you will have weld consequences. To test an aluminum MIG wire, take two 1/4 alum plates, six inches long. Start a 3/16, horizontal fillet weld approx. one inch from the end of the plate. Make the weld is four inches long. Don't weave use fore hand. After the weld has cooled, put welded plate in vice and use hammer to fold the plates in on the weld.

In contrast to steel welds, a good, alum weld with proper side wall fusion should break in most cases in the weld metal. Examine the broken weld surface for porosity. Clean looking, small pore porosity is found in the best of aluminum welds. Blackish looking small porosity often results from lubricants from the material surface. Small gray, oxidized weld porosity often results from air trapped in the joint or oxygen from the gas cylinders or lines. Extensive shiny porosity may be an indication of moisture pickup. Ensure synthetic impermeable hoses are used for your aluminum MIG gas delivery rather than neoprene or rubber hoses.

Weld porosity can be blamed on many materials that can contaminate both the weld wires and base metals. With aluminum, hydrogen is the prime cause. The bottom line keep the plates clean and at the ambient shop temperature. If necessary for your application grind the weld edges. Provide a protective cover for the alum weld wires. When the weld wires are not in use store in clean dry area. Good manufacturers of aluminum MIG wires will use extensive manufacturing controls to ensure you have a clean consistent MIG wire. There is a price to be paid for this weld wire quality. Compare your bargain priced aluminum wire with a quality and consistent product from a company like Alcotec.